Reference: ORINGSETDM
O-ring set 4x10pcs
Practical box. Set of O-rings, 4 sizes of 10 each.
Reference: KARABINAHADICEDM2
Plastic carabiner with metal lock for attaching octopus, manometer, etc. to jacket or wing.
1ml
Oxygen lubricant is a high PTFE, white paste resistant to moisture, water, steam, alkalis, acids, oils, oxygen, vacuum and long-term atmospheric influences. Long-term resistance to low and high temperatures. It is originally designed as a lifetime lubricant for bridge bearings where it resists long-term atmospheric influences. However, it has other, very broad application uses.
The oxygen lubricant is based on a high PTFE silicone gel, which gives the base aerogel a white appearance and excellent lubricating properties. The lubricant exhibits high thixotropy and, due to the low surface tension of the liquid component, has excellent flowability, so it easily fills surface micropores and acts as an effective separator. It wets well and adheres to dry surfaces of metals, ceramics plastics and glass, protecting against moisture, water, methanol, glycol and mineral oils.
Oxygen lubricant is applied as a lubricant for lubrication of fine mechanisms, slide valves of flow meters, valves, also in food industry. In electrical engineering as a damping and dielectric medium. It is also used as a high-temperature lubricant up to 220°C for slow-running rolling and sliding bearings, screws, in the lubrication of vacuum equipment and oxygen valves. It does not damage rubber or plastics. It has good preservative and durability parameters. Temperature range of use -70°C to 180°C, short-term up to 220°C.
Oxygen lubricant is non-flammable, not volatile even under high vacuum, and not disturbed by harsh water vapour. At operating temperatures of -70°C to 150°C it shows little change in consistency. At sustained temperatures above 180°C, the liquid component of the paste slowly oxidises in air and its products can be corrosive to some structural materials. The oxygen lubricant has very good resistance to dilute solutions of acids, alkalis and salts. It does not dissolve in water, glycol methanol and mineral oils, and does not resist gasoline, toluene, xylene, trichloroethylene and similar organic solvents.
Oxygen lubricant is biologically harmless and does not cause skin irritation. When the paste enters the eye, tearing occurs as in the case of foreign object penetration. According to Act 350/2011 Coll. and Regulation (EC) No 1272/2008 on classification, labelling and packaging of substances and mixtures (CLP), the lubricant is not classified as hazardous and does not meet the additional requirements for the preparation of a safety data sheet.
Reference: ORINGSETDM
Brand: Divemarine
Practical box. Set of O-rings, 4 sizes of 10 each.
Reference: REGULATORLEGEND
Brand: Aqualung
Backpack LEGEND automatic, Aqualung
Reference: PSLP2
Brand: OMNISWIVEL
With this "elbow" adapter, you can run the medium pressure hose lengthwise with the 1st stage body and also perpendicular to the 1st stage. Sometimes a perpendicular connection to the 1st stage is not quite ideal and there may also be a lack of ports for the medium pressure.
Reference: REDUKCEAGA
Brand: CZECH MADE
Reducer for Divator AGA mask for connection to standard hose
Reference: FLIGHTHOSE_0,75M-CERNA
Brand: Apeks
FLIGHT regulator hoses in various lengths.
Reference: REGULATORNECKLACEKIT
Brand: Apeks
Rubber with eye for hanging 2nd stage
Reference: KOLINKO90APEKS
Brand: Apeks
Between the 2nd stage and the hose with a fixed angle of 90°.
Reference: VAZELINADM
Brand: Divemarine
Silicon grease from Divemarine is an excellent agent for lubricating and preserving your equipment.
Reference: MATEREGBAG
Brand: SEAC SUB
Seac Mate Reg, diving regulator case, diameter 32, 5 cm.
Reference: SWITCHK
Brand: NORTHERN DIVER
Ergonomically designed solution to a single point breathing system. The switch block was developed to allow the diver to switch from main cylinder to reserve with a one-handed, easy action.